Mini Power bank with jump start function supply by UNICELL in Singapore
UNICELL a Leading power bank product supplier in Singapore Malaysia Indonesia Philippines and Thailand since 1986 , we carry more the 66,000 product
Order code : PB1626 (Portable Power Bank and Car Jump Starter )
Use 14000mAh high capacity high power polymer cells, fast charging and low self-discharge, cycles can reach 500 times. Support 12V car for emergency jump start, portable LED torch for illumination and with 5V USB power supply for mobile phone, PSP, MP3/MP4.tablet
To avoid cause accidents, make sure note the following cautions:
1. Take off the main unit within 30 seconds after starting the car.
2. Don't clip the two terminals at the same end on the battery.
3. Don't Disassemble the power bank unit!
* The smallest and lightest portable power bank with jump starting function for car.
* Use 14000mAh high capacity high power polymer cells, fast charging and low self-discharge rate ,500 time cycles life .
* Support12V car ( for emergency jump start the car ), portable illumination (LED torch )and mobile phone, PSP, MP3/MP4 ( 5V USB power supply socket )
* Pocket PC PDA, notebook (19V ) as well as other products charging / power supply.
* Multiple safety protection design .
Instructions for use:
1, Select the appropriate voltage and connect the electronic device to charging or power supply the unit
2, Press the switch to start charging when your device connected with PB1626 power bank ; If you unplug the cable,PB1626 will auto-sleep in one minute.
3, Five lights will flash circularly during the charging by PB1626 , when your device is full-charged all LED will light-up
4, During the charging for your device, LED lights indicate the balance power of built-in battery . Four lights indicate 80% balance, three lights indicate 60% balance, two lights indicate 40% balance and one light indicates 20% balance. The built-in battery is empty when all LED lights start to flash.
5, hold the switch five seconds to start If you want to use LED torch for illumination and select the status ( light, strobe, SOS, close) by pressing the switch to transform.
6, Store the product in a cool and dry place and away direct sunlight.
To start 12V car, please make sure PB1626 keep at least two LED lights are bright, then connect the red battery clip to the battery positive (+) and black clip to the battery negative (-) and insert the blue plug to the PB1626, turn on the ignition switch to the START position. Once the car is started, please disconnect the plug and remove the battery clips immediately.
Size: 7 * 3 * 15cm
Output: 5V/2A; 12V/2A; 19V/3.5A
Starting current: 200A
Peak Current: 400A
Fit or replace product model: (Cross refer or compatible)
Portable multifunction Jump Starter battery bank
Unicell International is not affiliated in any way with any of the manufacturers listed in this catalogue and the batteries sold in this catalogue have not been sponsored or approved by any of such manufacturers. Any trademarks or model numbers listed in this catalogue are identified for compatibility or cross-reference purposes only
Ask For Quote
If you any question about this product, please use the form below to send us your query.